Kindling splitter

AKoz

Member
Messages
7
Good Post Points
5
Location
Hunterdon County, NJ
Welder
Lincoln MIG and stick
My wood burning stove has a catalytic combuster that is only supposed to be exposed to wood smoke. Hence I start my fires with small pieces of kindling. I have used a hatchet to split these pieces but I figure that in the 35 years I've done this I've long ago used up my luck and it's just a matter of time before I chop a finger. I am looking for the smallest sizes of wood to be like a wooden matchstick or maybe 1/2 a typical no. 2 pencil. I tried some other options that didn't work out but I feel good about this one. The welding is sloppier than I would like but as long as I don't paint it it's good enough. It stands about 9" tall.
1672716940755.png1672716967382.png
 

jjef

Active member
Messages
36
Good Post Points
23
Location
Mi
Welder
Hobart 210, lx 235, Lincoln 140c
Nice idea wish I would have seen or thought of something like it before I bought my xl kindling cracker a few yrs ago.
 

Yomax4

Well-known member
Messages
169
Good Post Points
52
Location
MN.
Nice one. I built similar to take cherry and hickory down to size for the smoker.
 

RetiredMike

New member
Messages
4
Good Post Points
0
Location
Carlton
Welder
Unknown
I built something similar a few years ago. Not as fancy as the one featured here. Welded a metal felling wedge to a thick base plate and then put it into a square cloth basket I purchased at Walmart to keep the pieces in. I used a rubber mallet instead of a metal hammer to split the wood and to protect the sharp edge from accidental strikes with a hammer. Worked great. No pics of it though. Once I finish unpacking I will take a shot of it. Prior to that for larger work, I bolted two used tires together. Worked great for splitting large pieces as the ax handle only hit the rubber edge if my aim was wrong and the pieces stayed inside - which saved me from having to chase them down.

PS: Glad I joined this site. Lots of good info.
 

AKoz

Member
Messages
7
Good Post Points
5
Location
Hunterdon County, NJ
Welder
Lincoln MIG and stick
I built something similar a few years ago. Not as fancy as the one featured here. Welded a metal felling wedge to a thick base plate and then put it into a square cloth basket I purchased at Walmart to keep the pieces in. I used a rubber mallet instead of a metal hammer to split the wood and to protect the sharp edge from accidental strikes with a hammer. Worked great. No pics of it though. Once I finish unpacking I will take a shot of it. Prior to that for larger work, I bolted two used tires together. Worked great for splitting large pieces as the ax handle only hit the rubber edge if my aim was wrong and the pieces stayed inside - which saved me from having to chase them down.

PS: Glad I joined this site. Lots of good info.
 

AKoz

Member
Messages
7
Good Post Points
5
Location
Hunterdon County, NJ
Welder
Lincoln MIG and stick
It didn't take long before I realized the using a metal hammer to split the wood was not a good idea for the sharpness of the wedge. I made a small wood mallet instead and the splitter has turned out to have been a good idea.
 
Messages
6
Good Post Points
0
Location
North Carolina
I have an old axe head that I clamp into a vice for doing the same thing. I don't use big pieces of wood, usually 6" long. I have a cardboard box below it to catch the kindling.
 
Top