Search results

That's always a fear for sure that you'll hurt someone. I made sure to overbuild every part. And I doubled welded most places to guarantee it not coming off. Back roads are tough and trailer always takes a beating. Keep practicing and you'll get better. Make sure you know you're getting the...

Was looking to pull a small trench for an extension cord and figured with a single spline and hitch might do the trick. This meant I needed a 3 point hitch receiver first. This would also allow me to move our trailers easily without even getting off the tractor. And make other attachments...

I had a wood cart from Canadian Tire lasted about 2 season. Decided to make my own and practice be some new skills. Ordered a JD 32 model Bender and die. But it was backordered for 4 months. So decided to use the forge to make my 90 degree bends as I needed the cart to bring in our daily...

Thanks, I got some feedback to make sure not to use grade 8 threaded rod as they break (will have to check) and also supposedly weakens the frame unless you preheat and heat to cool.

Dad needed a tire mount for his spare tire on his trailer, so figured it was a good little project to do. Used up some 5/8 x 3" wide flat bar to create a 9x9" square piece, then plasma cut a 160cm circle out of it to make the back plate. Welded some threaded rod in to allow the tire to be...

Been using it with a full can of fuel and hasn't moved at all when riding. So far so good

Needed a new BBQ grease pan. Good time to take the English wheel for a spin.

Made a gas can holder for my dad's artic cat atv. Everything made from scratch from different flat bar. Fun project. Just needs primer and paint.

Hi, Actually i never thought of that till last week after redoing it - and i'm not 1/12 pitch compliant - i'm 1/6 pitch if that makes sense. I'm 18" high and it curves out to almost 10' My father in law has a motorized chair and is able to go up and down, but a little tippy at the end - will...

Built some wood shelters and needed some doors. Was looking at sliding doors that I can add and remove as needed when filling up the shed. Made the track from u channel and the wheel and mounts. Doors are recycled barn tin.

Replaced our steps with a ramp. Didn't want to do a normal straight ramp. So went with a curved metal frame ramp. Figured a lot of stuff out as I went. Especially for the curve. Father in law is in a wheel chair and I wanted him to come in without assistance. Also a easier way to bring our...

Bought a plasma cutter a few months back (Hypertherm 30xp) and been thinking about building a decent table to accommodate it for cutting and welding and storage. Came up with the following so far. It's still a work in progress with a bottom shelf to put the plasma cutter, welders, etc.. and...